Lexicon LXP-5 - REV 1 Owner's Manual page 35

LXP-5 Owner's Manual
Editing a User program
A User program can be modified in the same way as a Preset. First, turn
FUNCTION and SELECT to recall the desired program. Enter Edit mode by
holding the LEARN button in while turning FUNCTION to EDIT A or B.
Release the LEARN button and turn SELECT to a specific parameter.
ADJUST will now modify the parameter value.
To edit another parameter, simply turn FUNCTION and/or SELECT to the
positions corresponding to the desired parameter, and use ADJUST to
change parameter values.
If a parameter is chosen which is unavailable in the selected program,
ADJUST will have no audible effect.
Assign the parameters you find most useful to the ADJUST knob so that
these assignments will be stored with the program. After editing a User
program, the new sound can be stored at the same location (overwriting the
original program) or at a different location.
Using Bypass Mode
Setting FUNCTION to BYPASS puts the LXP-5 in Bypass mode. This mode
stops the LXP-5 from doing any signal processing by passing the wet portion
of the signal through the unit unchanged. Be sure to have the Mix control at
the 100% wet position (fully clockwise) when using Bypass.
Note: Bypass can be stored in a User memory location. Bypass can also be
activated in Algorithm Select mode or as a footswitch function (See
Footswitch Operation).
2-20