Lexicon LXP-5 - REV 1 Owner's Manual page 30

Front Panel Operation
Once a parameter has been chosen, its value can be edited by turning
ADJUST. Finer control of parameter values may be accessed via MIDI (see
Chapter 3: MIDI Operation ).
Special notes regarding parameters
Delay parameters have both a coarse and a fine range. The maximum delay
available is the sum of the largest coarse and fine values.
Pitch parameters are used together in the following manner:
Pitch Base/Select is used to select the base octave. Pitch Interval and Pitch
Adjust parameter values will be added to the base octave. You can choose
a base of unison, one octave down or two octaves down. Selecting Bypass
will remove the pitch shifter from the Pitch/Delay algorithm, and eliminate its
small processing delay.
Pitch Interval provides an adjustment range of more than an octave. Its
parameter value is added to the selected base octave. For example, to
adjust pitch between one octave down and unison, set the Pitch Base/Select
parameter to one octave down, then use the Pitch Interval parameter to
adjust the pitch from one octave down to one major 3rd up.
Pitch Adjust is used to fine tune the pitch between Pitch Interval parameter
settings. The Pitch Adjust parameter will be added or subtracted from the
Pitch Interval parameter value.
Size is shown in meters. The smallest value approximates one side of a
room. Cube this value to get the approximate room volume.
2-15