Driveline Clamp Cone Yoke Operating Instructions - Alamo Industrial Flex-Wing Mechanical Level Lift Rotary Cutter/Shredder EAGLE 10/15 Operator's Manual

ASSEMBLY

Driveline Clamp Cone Yoke Operating Instructions

Loosen the yoke clamp cone with a 11/16" (17mm)
wrench and remove the cone from yoke. Slide yoke
onto the shaft and align hole for clamping cone with
annular groove of gearbox shaft. Reinstall cone
and tighten (75 lb-ft torque). Push and pull the
driveline to ensure it is securely attached to the
shaft. Regularly check the driveline yoke to ensure
a tight connection. To remove the yoke, remove the
connecting cone and pull yoke off the shaft. If the
cone cannot be easily removed by hand, drive it out
from the other side using a hammer and punch.
NOTE: The clamping cone is serviced only as a complete assembly. Do not attempt to disassemble the
clamping cone.
Mower is now assembled and ready for pre-delivery checks.
EAGLE 15 02/08 Assembly Section 3-9
©2009 Alamo Group Inc.