HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 17

Installing the
Tower Module in a
CD-ROM Tower
WARNING
Note
If you are installing a CD-ROM Stand-Alone Module, or if your
Tower Module has already been installed in a tower, you can skip
this section.
The HP CD-ROM Server Tower Module is intended to be
installed in standard CD-ROM towers. The dimensions of the
CD-ROM server are the same as for standard CD-ROM drives,
which is 5.25 inch half-height.
To install the CD-ROM server, follow the steps below:
To avoid the risk of electrical shock or other injury,
disconnect power from the tower before removing the
cover, chassis, or enclosure.
1. Prepare the CD-ROM tower for the installation, for example,
remove the chassis cover.
2. Record the LAN hardware (MAC) address of the CD-ROM
server. You will need this number during the network
configuration described in chapter 3. The address is found on
the label on the bottom of the server.
An additional label that identifies the same LAN hardware
address is included with the CD-ROM server tower module.
This label is intended to be attached to the outside of the tower
chassis (the CD-ROM server may not be accessible after it is
installed).
3. Refer to the tower installation instructions for additional
hardware to be assembled onto the CD-ROM server prior to
installation.
4. Slide the CD-ROM server into the tower.
Basic Installation 2-5