Table of Contents
Advertisement
Error/Warning Displays
If for any reason an error occurs in the unit, the user is alerted of error or warning with the following displays.
Error/Warning
Inverter error
Warning of improper
operation status for the
camera settings
Battery level warning
Battery level error
Maintenance
• To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out to clean
the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor can cause a
malfunction.
• Never use thinner or benzene to clean this unit.
Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.
• Do not spray cleansers directly onto the monitor.
Water or similar substances getting inside the monitor can cause a malfunction.
Specifications
GENERAL
Power supply: DC 12 V (11.0 V to 17.0 V)
Input current: 1.5 A
indicates safety information.
Dimensions (W × H × D):
Weight:
Operating temperature:
Operating humidity:
Storage temperature:
Panel
Size:
Aspect ratio:
Number of pixels:
Display colors:
Angle of view:
Input connectors
VIDEO:
Analog component (YP
P
B
SDI:
VF:
GPI:
RS-232C:
36
Display
All the lamps on the side of
picture adjusting knobs flash at
1-second intervals.
is displayed.
The voltage display flashes.
"END BATTERY" is displayed for
approximately 3 seconds before
the power supply switches OFF.
218 mm × 166 mm × 64.7 mm
(8-9/16 inches × 6-9/16 inches × 2-9/16 inches)
1.5 kg (3.3 lb)
0 °C to 40 °C (32 °F to 104 °F)
10 % to 85 % (no condensation)
–20 °C to +60 °C (–4 °F to +140 °F)
7.9-inch V (Effective display area)
Panel: 16:9 (Effective display area)
Panel: 800 × 450 (Effective display area)
Approx. 16.77 million colors
Top-bottom direction: 110 °
1 line, BNC × 1 (Shared with the analog component Y input terminal)
):
1 line, BNC × 3
R
(Of these, the Y input terminal is shared with the VIDEO input terminal)
1 line, BNC × 1 (Optional)
D-sub, 15 pins × 1
D-sub, 9 pins × 1
D-sub, 9 pins × 1
Solution
Switch the power supply OFF once, then switch it
back ON again. If an error is still displayed, contact
the vendor where you purchased the unit.
Check the setting values of the camera.
Replace with a fully charged battery.
Replace with a fully charged battery.
Left-right direction: 120 °
Hide quick links:
Advertisement
Table of Contents
