Table of Contents
Advertisement
Main Menu
(continued)
■ CALIBRATION
Select CALIBRATION in the "SYSTEM CONFIG" menu to open the following menus.
Sub menu
AUTO
1
CALIBRATION*
2
RESET*
*1 "EXECUTING" is displayed during "AUTO CALIBRATION" and "COMPLETE" appears when calibration ends.
"INCOMPLETE" appears if calibration could not be completed.
*2 When "RESET" ends, "COMPLETE" appears.
Performing AUTO CALIBRATION
1. Press [
,
] in the "SYSTEM CONFIG" menu,
select the [CALIBRATION] submenu and press
[ENTER].
2. Press [
,
], select the [AUTO CALIBRATION]
submenu and press [ENTER].
[AUTO CALIBRATION]
3. Select "YES" and press [ENTER].
This starts calibration.
[AUTO CALIBRATION]
xxxxxxxxx indicates that one of the following
messages with the meaning listed below appears.
EXECUTING: Operation in progress
COMPLETE: Operation completed
INCOMPLETE: Operation did not complete.
(Check RS-232C cable connection.)
Setting
Description
Connect a CA-210 color analyzer and use this submenu to make a
calibration.
Select "AUTO CALIBRATION" and select "YES" in the confirmation
screen that appears to start calibration.
Returns calibration data to their factory defaults.
Select "RESET" and select "YES" in the confirmation screen that
appears to return calibrated values to their factory defaults.
RESET operation
1. Press [
,
] in the "SYSTEM CONFIG" menu,
select the [CALIBRATION] submenu and press
[ENTER].
2. Press [
,
], select the [RESET] submenu and
press [ENTER].
[RESET]
3. Select "YES" and press [ENTER].
This starts calibration.
[RESET]
xxxxxxxxx indicates that the following message with
the meaning listed below appears.
COMPLETE: Operation completed
31
Advertisement
Table of Contents
