Table of Contents
Advertisement
How to Configure an Infrastructure Mode Profile
Follow the instructions below to configure an infrastructure mode profile for connecting to an
access point.
1. Run the WG511 Configuration Utility.
Make sure the WG511 software is installed and the WG511 is fully inserted in an available
a.
CardBus slot in your PC.
Open the configuration utility by clicking on the WG511 icon
b.
system tray.
Figure 3-2: Configuration tab page
Click on the Configuration tab to display the view shown above.
c.
2. Configure the wireless Network settings.
In the Network section, be sure that Infrastructure is selected for the Network Mode.
a.
Enter the SSID. This is also called the Wireless Network Name.
b.
Configuration
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
in the Windows
3-23
Advertisement
Table of Contents
