Quick Start - DigiTech RP-20 VALVE User Manual

Quick Start

For those of you who prefer to burn now and read later, we've included this Quick Start section to get you up and running.
Connect Cables:
Connect guitar into the Input jack (located on the rear of the RP-20). Now run from the Output of the RP-20 to the Input of the either the
Guitar Amp, Power Amp or Mixing board.
Apply Power:
Note: When applying power to the RP-20 Valve, it is recommended that the <Input> and <Output> be turned down prior to powering up
the unit.
Adjust Input and Output:
Use the <Input> level knob on the rear panel to adjust the Input level, so that the loudest guitar signal occasionally lights the clip LED
indicator. Now adjust the <Output > level knob on the rear panel of the RP-20 Valve to the desired output level .
Select Preset:
Begin playing your guitar, and choose any preset using the <Data> wheel or pressing any one of the ten footswitches. User Presets 1-100 are
duplicates of the Factory Presets. They are user-programmable. You can modify and store them as you want. Factory Presets 1-100 are not user-
programmable and cannot be overwritten.
II
Data
RP-20 Valve
User Guide