A Quick Tour Of The S-200; The Front Panel - DigiTech S200 User Manual

S-200

A Quick Tour of the S-200

The Front Panel

1) Display - This large custom display is where you receive information for programming and operation of the S-200. This information
includes: effect types and parameters and all Utility mode functions including Contrast, Dry level, MIDI program information,
Factory Reset and Footswitch set-up.
2) Program Descriptions - This list tells you the factory program list of all Factory 99 programs in the S-200.
3) Program/Data Wheel - In Program mode, this wheel is used to change programs and when the unit is in Edit mode it is used to select
effects and change parameters.
4) Program Button -This button returns the S-200 to program mode when pressed.
5) Configuration Button - This button is used to select Configuration mode. Once pressed, use the <Program/Data> wheel to select a
different effect configuration for the selected program.
6 a-d) Effect Parameter Editing Buttons - These four buttons allow you to do all parameter editing of effects in Edit and Utility modes in
7) Engine A/B Select - This button selects the Engine A and B effect engine modules. Successive presses of this button will toggle between
Engines A/B in effect configurations 2-5. Once this button is pressed and the Engine effect module has been selected,
use the <Program/Data> wheel to select the effect to be used in this effect engine module.
8) EQ/Gate - This button (in conjunction with the four parameter buttons) are used to adjust the three band EQ and Noise gate threshold and
release. Press once to select the EQ and press twice to select the Noise Gate.
9) Utility - This button is used to access all Utility mode functions including: Dry signal path On and Off, selecting the MIDI channel,
adjusting the display contrast and footswitch set-up.
10) Preview - This button produces a brief reference tone to audition effect sounds without the use of an input signal.
11) Store Button - This button is used to store program modifications in the S-200.
12) Bypass - This button is used to Bypass all of the digital effects in the S-200 and allow the original dry signal to pass through the S-200.
User Guide
1
Stereo Large Hall FACT
USER
UTIL
L
L EDIT
ng eq
Hall
CHNG
R R
LINK
MIDI
4 5 6 a-d 7 8 9 10 11 12
conjunction with the <Program/Data> wheel.
2 3
Section -1 Introduction
3