Quick Start; Introduction; Modification Decals - DigiTech C1 Owner's Manual

Quick Start

For those of you who prefer to burn now and read later, we've included this Quick Start reference section to
help you do it right the first time.
Connect Cables: Make sure the power is off before connecting or disconnecting the cable to the Control One.
Using a standard 5-pin DIN cable (MIDI-type), connect the Control One to the jack on the rear panel of the
2112 SGS, GSP-2101, Valve FX or Legend II where labeled FOOT CONTROLLER. DO NOT CONNECT
ANYTHING BUT THE CONTROL ONE TO THE FOOT CONTROLLER JACK ON THE REAR
PANEL OF THE 2112 SGS, GSP-2101, VALVE FX OR LEGEND II! DOING OTHERWISE MAY
DAMAGE THE DEVICE. IF MIDI CONTROL IS DESIRED, CONNECT THE MIDI DEVICE(S)
TO THE MIDI IN JACK.
Apply Power: When you turn on the 2112 SGS, GSP-2101, Valve FX or Legend II, the foot controller will
also power up.
Select Program : Begin playing your guitar and choose any program using the footswitches or (2101, Valve
FX or Legend II only), by pressing the Program footswitch once and then entering the desired program num-
ber using the number footswitches. Once the program has been selected, the unit will change to that program.
Select Bank (2112 Only): You can scroll through the 19 Banks of the 2112 by simply pressing either the
<Bank Up> or <Bank Down> footswitch on the Control One. Once a bank is selected, press one of the flash-
ing footswitches and the 2112 will move to the selected bank.

Introduction

Congratulations, and thank you for your purchase of the Control One Foot Controller. The Control One is a
powerful remote foot controller that allows you to take full advantage of all the high-performance real-time
control capabilities of the 2112 SGS, GSP-2101, Valve FX or Legend II Guitar Processors. In addition, the
Control One is also compatible with Johnson Amplification products such as Millennium 150 and Marquis
100. The unit is equipped with ten programmable footswitches, plus dedicated bypass and Program / Bank
selector switches, along with a continuous controller pedal built into the pedalboard.
This owner's manual is your key to understanding the powerful world of the Control One. Read it carefully.
After you've had time to familiarize yourself with the unit, try experimenting with unusual continuous con-
troller Parameter links. You may get some interesting results. DigiTech is always looking for new ideas, so if
you feel that you've created something unique, send us your ideas at the address on the back cover of this man-
ual. Good luck, and thank you for choosing DigiTech.
Control One Modification Decals (2101, Valve FX or Legend II Only)
Included with the Control One foot controller, are two Modication decals. These decals are to be used in con-
junction with either the 2101, Valve FX or Legend II Preamp/Processors. These decals are provided to enable
the User to operate the Control One effectively using any of the units listed above.
Applying Decals
The decals are to be placed on the Control One in the specified areas:
BYPASS - This decal is placed directly over the footwitch marked: Bank Down/(Hold)Bypass.
PROGRAM/BANK/TUNER - This decal is to be placed directly over the footswitch marked:
Control One Owner's Manual
BANKUP/(Hold)TUNER.
Quick Start and Introduction
3