Preparations; Installing The Stand - Sanyo LCD-32R45F Instruction Manual

Preparations

Assembling the Stand
If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to
mount your TV on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure
of your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or
improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent
accidental scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can
cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.

Installing the stand

NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for
comparative purposes only.
To install the stand:
Locators
Stand
Secure with
four screws
1. Remove the stand from the box and place it on a table or
bench.
You must pay attention to the direction of the stand. The
wide portion of the stand should go towards the front of
the TV.
2. Lay your TV flat (screen down) on the edge of a table or
bench. Make sure that you put down a soft cushion or cloth
so that your TV is not scratched.
3. Put the stand close to the TV back, align the stand with the
TV by moving the stand steadily until the Stand Locators
align with the locating grooves on the stand column. And
align the screw holes on the TV back with the holes in the
stand column, then secure the stand to the TV with
provided screws .
To remove the stand from the TV, perform these
steps in reverse order.
6