Cleaning And Maintenance - Cuisinart Coffee On Demand DCC-3000 Instruction Booklet

note: The maximum capacity for ground coffee is
16 scoops (16 tablespoons) for this coffeemaker .
Exceeding this amount may cause overflow if the
coffee is too finely ground .
5. Before brewing coffee
Make sure the water reservoir is on the unit and the
reservoir lid is on the reservoir . Plug into an electrical
outlet .
6. power unit on
Turn the Function knob to Brew, press the ON/OFF
button, and the blue indicator light will turn on . Or,
set the Auto On function (see above) and the green
indicator will light .
7. after brewing
When the brewing cycle has completed, five beeps
will sound .
NOTE: The dispenser light illuminates the cup area
when you press the lever to pour coffee into your mug .
CLEANING AND
MAINTENANCE
Always turn coffeemaker off and remove the plug from
the electrical outlet before cleaning .
Lift up the reservoir cover . Remove and discard the filter
and ground coffee .
WARNING
Caution: the coffee reservoir may contain hot coffee.
allow to cool before lifting.
Remove the brew basket, coffee reservoir and drip tray .
These can be washed in warm, soapy water and
rinsed thoroughly, or cleaned in the upper rack of the
dishwasher . Dry all parts after use .
do not put any water in the unit once the filter basket and
coffee reservoir have been removed. Wipe the area under
the reservoir with a damp cloth.
Neither the reservoir lid nor the reservoir should be put
into the dishwasher . Clean them with a damp, soapy,
non-abrasive cloth and rinse thoroughly . Do not dry
the inside of the water reservoir with a cloth, as lint
may remain .
Do not use any scouring agents or harsh cleansers on
any part of the coffeemaker .
Never immerse base unit in water or other liquids . To
clean base, simply wipe with a clean, damp cloth and
dry before storing . Fingerprints and other blemishes on
the housing can be washed off with soap and water or
a nonabrasive cleaning solution . Never use rough,
abrasive materials or cleansers to clean the warming
plate . Do not dry the inside of the water reservoir with a
cloth, as lint may remain .
maintenance: Any other servicing should be performed
by an authorized service representative .
decalcification
Decalcification refers to the removal of calcium
deposits that form over time on the metal parts of
the coffeemaker .
For best performance from your Coffee on Demand
Coffeemaker, decalcify the base unit from time to time .
The frequency depends upon the hardness of your tap
water and how often you use the coffeemaker . The
flashing Clean light will indicate when you should clean
your coffeemaker .
note: Before decalcifying your coffeemaker, remember
to remove the charcoal water filter from the water filter
holder located in the water reservoir .
If the Clean light begins to flash when the coffeemaker
is turned on, it is telling you that the calcium buildup is
interfering with the functioning of your coffeemaker and
the flavor of your coffee . To clean, fill the water reservoir
to capacity with a mixture of ¹⁄ ³ white vinegar and ²⁄ ³
water . Press the Clean button . When the self-clean light
glows, turn the coffeemaker on by pressing the
ON/OFF button . The Clean light will shine steadily . The
coffeemaker is now in Clean mode . One cycle should
be sufficient to adequately clean the coffeemaker . When
the cycle is completed and the five beeps sound, the
coffeemaker will shut off . Turn the coffeemaker on to
see if the Clean light continues to flash . If it does, turn it
off and then repeat the cleaning procedure with a fresh
solution of vinegar and water .
If the Clean light no longer flashes, turn the coffeemaker
off and then run one cycle of fresh cold water through
the unit before using the unit again to brew coffee .
8
™