Delta Electronics IPM- C Series Specification Sheet page 6

7.2 Initial Power Up
1) Turn the power
either converter) and increase the input voltage (use DMM2 to monitor the voltage) until it
reaches the desired value.
2) Set the switch SW1 to "OFF" position to enable the power module.
3) The converter is now operat
value for the nominal output voltage) and channel 2 of the oscillosc
for the nominal output voltage).
4) Set the switch SW1 to the "ON" position after performing each test.
8.0 Tests and Evaluation
8.1 Input Characteristics
8.1.1 Input Voltage Ra
The IPM04C Series of DC/DC converters will operate at full loa
th e output of 3.3V, the input voltage range is from 4.0Vin to 5.5Vin. The IPM12C Series
DC/DC converters will operate at full load from 8Vin to 14Vin for 12Vin (nominal) types. The
converters feature input under-voltage protection, which will not allow the converter to start
up unless the input voltage exceeds the turn-on voltage threshold.
Test
1 ) Turn on the fan.
2) Se t the input voltage to the desired operating point while monitoring DMM2.
3) Set the switch SW
4) Test the input under voltage function while observing DMM2, DMM3 and cha
oscilloscope. Increase the input voltage until the output of the c
appropriate value. This will occur between 2.40 and 2.70 volts for IPM04C modules and
between 7.6 to 8.0 volts for IPM12C modules. Please refer to the appropriate converter
data sheet for the detailed specification.
8.1. 2 No Load Input Current Test
1) Turn on the fan.
2 ) Set the input voltage to the desired operating point while monitoring DMM2.
3) Set the switch SW
4) Remove/disable the output electronic load or resistive load.
5) Note the input current from DMM1.
6) The result is the No-Load Input current of the DC/DC conver
The No-Load Input Current will be a
20 to 70mA for the IPM04C series depending on the model u
refer to the data sheet for the detailed specification).
supply ON, set the current limit on power supply (refer to specification of
ing, which can be verified by observing the DMM3 (appropriate
nge and Under-Voltage Lockout
1 to the "OFF" position to enable the converter.
1 to the "OFF" position to enable the converter.
round 20 to 85mA for the IPM12C series and around
ope (appropriate value
d from 3.0Vin to 5.5Vin. For
nnel 1 of the
onverter reaches the
ter.
nder evaluation. (Please
6