Linksys WRT54G2 - Wireless-G Broadband Router User Manual page 9

Chapter 3
Static IP
If you are required to use a permanent IP address to
connect to the Internet, select Static IP.
Internet Connection Type > Static IP
Internet IP Address
This is the Router's IP address, when
seen from the Internet. Your ISP will provide you with the
IP Address you need to specify.
Subnet Mask
This is the Router's Subnet Mask, as seen
by users on the Internet (including your ISP). Your ISP will
provide you with the Subnet Mask.
Gateway
Your ISP will provide you with the Gateway
address, which is the ISP server's IP address.
Static DNS
Your ISP will provide you with at least one
DNS (Domain Name System) server IP Address.
PPPoE
Some DSL-based ISPs use PPPoE (Point-to-Point Protocol
over Ethernet) to establish Internet connections. If you are
connected to the Internet through a DSL line, check with
your ISP to see if they use PPPoE. If they do, you will have
to enable PPPoE.
Internet Connection Type > PPPoE
User Name and Password
Password provided by your ISP.
Connect on Demand: Max Idle Time
the Router to cut the Internet connection after it has been
inactive for a specified period of time (Max Idle Time). If
your Internet connection has been terminated due to
inactivity, Connect on Demand enables the Router to
automatically re-establish your connection as soon as you
attempt to access the Internet again. To use this option,
select Connect on Demand. In the Max Idle Time field,
enter the number of minutes you want to elapse before
your Internet connection terminates. The default is 5
minutes.
Keep Alive: Redial Period
Router will periodically check your Internet connection. If
Wireless-G Broadband Router
Enter the User Name and
You can configure
If you select this option, the
Advanced Configuration
you are disconnected, then the Router will automatically
re-establish your connection. To use this option, select
Keep Alive. In the Redial Period field, specify how often
the Router should check the Internet connection. The
default is 30 seconds.
PPTP
Point-to-Point Tunneling Protocol (PPTP) is a service that
applies to connections in Europe only.
Internet Connection Type > PPTP
If your ISP supports DHCP or you are connecting through
a dynamic IP address, then select Obtain an IP Address
Automatically. If you are required to use a permanent IP
address to connect to the Internet, then select Specify an
IP Address. Then configure the following:
Specify an IP Address This is the Router's IP address,
•
as seen from the Internet. Your ISP will provide you
with the IP Address you need to specify.
Subnet Mask
This is the Router's Subnet Mask, as
•
seen by users on the Internet (including your ISP). Your
ISP will provide you with the Subnet Mask.
Default Gateway
Your ISP will provide you with the
•
IP address of the ISP server.
DNS 1-3
Your ISP will provide you with at least one
•
DNS (Domain Name System) server IP address.
PPTP Server IP Address Your ISP will provide you with
the IP address of the PPTP server.
Username and Password
Password provided by your ISP.
Connect on Demand: Max Idle Time
the Router to cut the Internet connection after it has been
inactive for a specified period of time (Max Idle Time). If
your Internet connection has been terminated due to
inactivity, Connect on Demand enables the Router to
automatically re-establish your connection as soon as you
attempt to access the Internet again. To use this option,
select Connect on Demand. In the Max Idle Time field,
enter the number of minutes you want to elapse before
your Internet connection terminates. The default is 5
minutes.
Enter the Username and
You can configure
5