FUTABA FP-8SGAP Instruction Manual page 37

ELEVN (AILERON + ELEVATOR)
• This type of mixing can be used with tailless and
delta wing aircraft and flying discs.
• Install and connect the servos as shown in Fig.
75. Always connect the Right side servo to CH1
(Aileron).
• Aileron differential can be adjusted with Trim-
mer 15.
Connect to-
channel 2
(elevator).
V.TAIL (ELEVATOR + RUDDER)
•This mixing is used for gliders, scale model
Bonanzas, and other V-Tail aircraft.
• Install and connect the servos as shown in Fig.
78. Always connect the servo to the Right Rud-
dervator to CH2 (Elevator).
• Set Switches 16 and 17 as shown in Fig. 79.
Connect to
channel 4 (rudder)
* When connecting the linkage, connect channel 2
(aileron servo) to the right wing rudder.
-Connect to
channel 1
(aileron).
Pig. 75
Connect to
channel 2 (elevator).
Fig. 78
Use channel 1 (aileron
servo) at the right rudder.
Used channel 2 (elevator) for the right rudder.
Fig. 76
Fig. 77
Fig. 79
Fig. 80