FUTABA 8UHPS Instruction Manual page 18

When you first turn on your transmitter, a confirmation beep sounds, and the screen
shown below appears. Before flying, or even starting the engine, BE SURE that the
model name appearing on the display matches the model that you are about to fly! If
you don't, servos may be reversed, and travels and trims will be wrong, leading to an
immediate crash.
Model Name
(to change, see p. 44)
Modulation
indicator
PCM shown
Throttle trim
display
Timer On/Off Indicator
(see P. 34 to set timer)
The timer appears if one
of the cursor keys is
pressed.
Note: trim display can be displayed in reverse video (see page 40)
MODE key – use to
select desired function
while programming
Press these two keys to
turn on Advance Menu
Current Screen Display
< > Normal screen
< = Advance menu screen
> = Basic Menu screen
Aileron trim
Rudder
trim
Total timer display (hours:minutes)
Shows the cumulated ON time
Reset by pressing (+ )/(-) keys together
Press these two
keys to turn on
Basic Menu
DATA INPUT keys – use
these to input numbers or
settings
15
Current model memory
(upper = first digit,
lower = second digit)
Model 01 shown
Elevator trim display
Battery voltage
(Alarm goes off at 8.5 V)
CURSOR keys – use to
select item to be set or
changed in the screen