Inserting The Bobbin - ELNA 7200 Instruction Manual

Inserting the Bobbin

Place the bobbin in the bobbin case with the
thread running counterclockwise.
Guide the thread into notch q on the front side of
the bobbin case.
q
Hold the bobbin with your right hand and pull the
w
thread to the left, through the tension spring
blades w.
Continue pulling the thread lightly until the thread
slips into notch e.
Pull out about 15 cm (6˝) of thread.
e
Replace the bobbin cover plate.
Refer to the chart shown on the bobbin cover
plate to check the threading.
24