How To Read The Machine Set-Up Information - Example: Straight Stitch; Lcd Screen (Model 3230 Only); Lcd Screen; Stitch Length Dial - ELNA 3210 Instruction Manual

1
2
3
7
1
3
2
5
5
1 - 4
6
4
8
4
6
How To Read the Machine Set-Up Information –
Example: Straight Stitch
Before sewing begins, the machine must be set up for
the stitch/technique. Each technique in Section III will
show the setup information using illustrations.
1
Select Stitch
Set stitch selection knob to illustrated stitch. See page
21.
Which Presser Foot to Use
2
Use presser foot shown for the best sewing result. See
page 5.
3
Set Thread Tension Dial (Model 3230 only)
Set thread tension to "Auto". See page 8.
Set Thread Tension Dial (Model 3210 only)
4
Set thread tension to 4. The fabric, thread and number of
layers of fabric might change where tension should be
set. Variation range is 3 to 5. See page 8.
5 Set Stitch Width/Needle Position Dial
Set this dial to 0. Setting can be changed to 6.5 for left
position. See page 21-22.
6 Set Stitch Length Dial
Set this dial to 2.5. Setting should be changed according
to fabric weight. Variation range is 1 to 4. See page 22.
Drop Feed Dog
7
If a technique requires the feed dog to be lowered, this
symbol will be shown. See page 9.
8 Change Foot Pressure Dial
If a technique requires a setting other than "3", this
symbol will be shown. See page 6.

LCD Screen (Model 3230 Only)

Standard machine settings for stitches are displayed on
the LCD screen. Turn the stitch selection knob and for a
few seconds the stitch name will scroll to the left to
display the recommended foot.
1
Stitch Illustration
2 Stitch number
Stitch width/needle position – 0 or 6.5
3
4 Stitch length – 1.5 to 4
5 Stitch name
6 Presser foot
20