Top View - Pioneer DRM-3000 Operating Instructions Manual

A HARDWARE TOUR

TOP VIEW

0
0 Function switch
ON OFF
This switch is used to check the
device before shipment, and its
setting should never be changed.
RPC (Region Play Control) Set switch
ON = Stay in RPC Phase I mode
OFF = Start RPC Phase II mode (Never
return to Phase I mode after Phase
II mode is used)
TO INSTALL THE DRIVE
For instructions on how to open the
a c c e s s d o o r s , s e e t h e o p e r a t i n g
instructions for the DRM-7000 disc
changer.
Before installation, be sure to specify the
following settings at the rear of each drive
to be installed.
¶ SCSI ID assignment
Specify the SCSI IDs to be used so as
to ensure that the same SCSI ID is not
assigned by more than one drive on the
same SCSI bus.
¶ Termination
Set the termination switch of the last
drive in the SCSI chain to the ON
position.
8
<DRC1106>
En
¶ Set ON at the time of shipping from the plant.
¶ For a DVD Video playback system (computer)
for Phase I, please use with Phase I. When the
DVD Video playback system (computer) and the
drive have different region codes, DVD Video
playback is not possible.
Set the jumper switch to OFF only when use of
a drive corresponding to Phase II has been
specified clearly for the DVD Video playback
system (computer). The drive will be initialized
automatically and will operate in Phase II mode.
Warning about static electricity
Always be sure never to touch the
contacts or ports when operating
drives.
Also be sure to touch a metallic surface
on the changer before installing
additional drives to the changer.