Removing the front service housing components (wide models only)
This section pertains to models with the front service housing option.
Removing the system and bezel latches
Follow these steps to remove the rear and bezel latches from the 4800 unit:
1. Set the unit on a flat surface.
2. See Figure 17 on page 29 and follow the steps to remove the front bezel.
3. Remove the power supply screw holding the system latch and retain for reuse.
Figure 55. Removing the system latch
4. Remove the system latch and discard.
5. Align the new system latch to the corner of the unit as shown in Figure 55,
64
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
insert screw and tighten.
Updated July 14, 2008