Hooking Up The Tv/Vcr - Magnavox MC09D5MG - 9" Tv/vcr Combination Owner's Manual

MC09D5MG 4/12/02 12:20 PM

6 Hooking Up the TV/VCR

1
Hook up your TV/VCR using one of the connections shown.
A
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
B
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
C
Hooking Up Your TV/VCR With the
Supplied Rod Antenna
To install the supplied rod antenna, push the
stem of the antenna into the antenna hole on the
back of the TV/VCR. Connect the antenna wire
to the ANT(enna) Jack on the back of the
TV/VCR as shown. Extend the antenna and adjust
its length, direction, and angle for the clearest
picture.
2 Connect the AC power cord to the AC 120V jack on the back of the
TV/VCR. Plug the AC power cord into an AC power outlet. Use only the
supplied AC power cord.
3
Before you turn on the TV/VCR, go to
page eight.
• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is
bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.
Crooked Pin
Page 6
Helpful Hint
Plug
Bent pin
Cable
Connect a Cable signal
or an antenna to the
ANT(enna) Jack.
ANT
ANT
Connect the Cable signal to
the IN Jack on the Cable Box.
OUT IN
RF coaxial cable
(not supplied)
ANT
Rod Antenna
(supplied)
ANT
ANT
Straight Pin
DC 13.2V
AC 120V
DC 13.2V
ANT
AC 120V
DC 13.2V
AC 120V
DC 13.2V
ANT
AC 120V