Connectors; Rear Panel Connectors; Internal Connectors - Asus PUNDIT-AE3 Manual

4.3.1 4.3.1

Rear panel connectors

Rear panel connectors
4.3.1 4.3.1 4.3.1 Rear panel connectors Rear panel connectors Rear panel connectors
Refer to section "1.3 Rear panel" for a description of the rear panel I/O ports.
4.3.2 4.3.2 4.3.2

Internal connectors

Internal connectors Internal connectors
4.3.2 4.3.2 Internal connectors Internal connectors
1 . 1 . 1 . 1 . I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )
1 . I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E ) I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )
These connectors are for Ultra DMA 100/66/33 signal cables. The
Ultra DMA 100/66/33 signal cable has three connectors: a blue
connector for the primary IDE connector on the motherboard, a black
connector for an Ultra DMA 100/66/33 IDE slave device (optical drive/
hard disk drive), and a gray connector for an Ultra DMA 100/66/33 IDE
master device (hard disk drive). If you install an optical drive and an IDE
HDD, you must configure the optical drive as a slave device by setting
its jumper accordingly. Refer to the optical drive or HDD documentation
for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE
devices.
®
IDE connectors
A S U S P u n d i t - A E 3 A S U S P u n d i t - A E 3 A S U S P u n d i t - A E 3 A S U S P u n d i t - A E 3 A S U S P u n d i t - A E 3
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
4 - 5 4 - 5 4 - 5 4 - 5 4 - 5