Asus P2-M3A3200 User Manual page 36

3 IDE connector (40-1 pin PRI_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your devices.
M3R78L IDE Connector
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select", ensure that all other device
jumpers have the same setting.
4. CPU Fan connector (3-pin CPU_FAN)
The fan connectors support cooling fans of 350 mA~740 mA (8.88 W max.)
or a total of 1 A~2.22 A (26.64 W max.) at +12V. Connect the fan cables to
the fan connectors on the motherboard, ensuring that the black wire of each
cable matches the ground pin of the connector.
3-6
M 3 R 7 8 L
R
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133 / 100 / 66 IDE devices.
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
Mode of
Cable connector
device(s)
-
Master
Slave
Master
Black or gray
Slave
Chapter 3: Motherboard info
Black
Black
Gray