Removing Accessories; Charging Battery Pack - Bosch 11225VSRH - 3/4" SDS-plus Rotary Hammer Operating/Safety Instructions Manual

BM 1619929600 11/02 11/18/02
When removing the bit from
WARNING
!
the tool avoid contact with
skin and use proper protective gloves when
grasping the bit or accessory. Accessories
may be hot after prolonged use.
To remove an accessory, pull the locking
sleeve backwards (towards the rear of tool),
while pulling the accessory outward. All
accessories should be wiped clean after
removing.
RELEASING AND INSERTING BATTERY PACK
Set Forward/Reversing lever to the center
(off position). Before inserting the battery
pack, remove the protective cap if
necessary. Slide charged battery pack into
the handle until the battery pack locks into
position.
BATTERY PACK
LOCKING BUTTON
Plug charger cord into your standard power
outlet. Before inserting battery pack, remove
protective cap, then insert battery pack into
charger. The charger's green indicator light
will begin to "BLINK". This indicates that the
battery is receiving a fast charge. Fast-
charging will automatically stop when the
battery pack is fully charged.
When the indicator light stops "BLINKING"
(and becomes a steady green light) fast
charging is complete, and an acoustical
signal sounds for a period of approximately
2 seconds which indicates that the battery is
completely charged.
The battery pack may be used even though
the light may still be blinking. The light may
require more time to stop blinking
depending on temperature.
8:18 AM Page 10

REMOVING ACCESSORIES

To remove the battery pack, press back the
unlocking button and pull the battery pack
downward.

CHARGING BATTERY PACK

The purpose of the green light is to indicate
that the battery pack is fast-charging. It
does not indicate the exact point of full
charge. The light will stop blinking in less
time if the battery pack was not completely
discharged.
When charging several batteries in
sequence, the charge time may slightly
increase.
When the battery pack is fully charged,
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool.
To prevent fire or injury when batteries are
not in tool or charger, always place
protective cap onto end of battery pack.
-10-
PROTECTIVE
CAP