Error Codes And Messages - Texas Instruments TI-Nspire Reference Manual

Error codes and messages

When an error occurs, its code is assigned to variable errCode. User-defined programs and
functions can examine errCode to determine the cause of an error. For an example of using
errCode, See Example 2 under the
Note: Some error conditions apply only to TI-Nspire™ CAS products, and some apply only to
TI-Nspire™ products.
Error code Description
10 A function did not return a value
20 A test did not resolve to TRUE or FALSE.
Generally, undefined variables cannot be compared. For example, the test If a<b will cause this error if either a or
b is undefined when the If statement is executed.
30 Argument cannot be a folder name.
40 Argument error
50 Argument mismatch
Two or more arguments must be of the same type.
60 Argument must be a Boolean expression or integer
70 Argument must be a decimal number
90 Argument must be a list
100 Argument must be a matrix
130 Argument must be a string
140 Argument must be a variable name.
Make sure that the name:
•
•
•
•
See the Calculator section in the documentation for more details.
160 Argument must be an expression
165 Batteries too low for sending or receiving
Install new batteries before sending or receiving.
170 Bound
The lower bound must be less than the upper bound to define the search interval.
180 Break
d
The
190 Circular definition
This message is displayed to avoid running out of memory during infinite replacement of variable values during
simplification. For example, a+1->a, where a is an undefined variable, will cause this error.
200 Constraint expression invalid
For example, solve(3x^2-4=0,x) | x<0 or x>5 would produce this error message because the constraint is
separated by "or" instead of "and."
210 Invalid Data type
An argument is of the wrong data type.
220 Dependent limit
command, page
Try
does not begin with a digit
does not contain spaces or special characters
does not use underscore or period in invalid manner
does not exceed the length limitations
c
or key was pressed during a long calculation or during program execution.
.
105
TI-Nspire™ Reference Guide 137