In Case Of Difficulty - Texas Instruments TI-34 - MultiView Scientific Calculator User Manual

How to remove or replace the battery
The TI-34 MultiView™ calculator uses one 3 volt CR2032
lithium battery.
Remove the protective cover and turn the TI-34 MultiView
calculator face downwards.
• With a small screwdriver, remove the screws from the back
of the case.
• From the bottom, carefully separate the front from the
back. Be careful not to damage any of the internal parts.
• With a small screwdriver (if required), remove the battery.
• To replace the battery, check the polarity (+ and -) and
slide in a new battery. Press firmly to snap the new battery
into place.
Important: When replacing the battery, avoid any contact
with the other components of the TI-34 MultiView
calculator.
Dispose of the dead battery immediately and in accordance
with local regulations.

In case of difficulty

Review instructions to be certain calculations were performed
properly.
Check the battery to ensure that it is fresh and properly
installed.
Change the battery when:
• & does not turn the unit on, or
• The screen goes blank, or
• You get unexpected results.
44