Delta 31-552 Instruction Manual page 6

STAND AND ELECTRICALS
If you purchased your machine with the optional steel
stand and electricals, the stand is shipped as shown in
Fig. 2. The switch (A) Fig. 2 and motor (B) Fig. 3 are
completely assembled to the stand and the necessary
wiring from the motor to the switch has been completed.
ASSEMBLING
MACHINE TO STAND
Place the machine on the stand with the arbor pulley
over the opening (A) Fig. 4, on the top of the stand. The
drive belt is shipped on the arbor pulley of the machine
and must be inserted down through the opening (A). The
disc end of the machine is to be positioned on the same
end of the stand that the switch (B) Fig. 4, is located. Line
up the four holes on the base of the machine with the
four holes (C) in the top of the stand. Place a 3/8" flat
washer on a 3/8"-16x3" hex head screw (D) Fig. 5, (two
are shown), insert screw through the hole in the base of
the machine and the hole in the top of the stand. Thread
a 3/8"-16 hex nut onto the screw and tighten securely.
Repeat this process for the three remaining holes.
ASSEMBLY
B
B
6
A
Fig. 2
Fig. 3
A
C
Fig. 4
D
Fig. 5
C