Advertisement
RADIO MNTR: Press this button to hear the radio
when you are fast forwarding or reversing a cassette
tape. You can use the TUNE, SEEK and PSCAN buttons
while in the radio monitor mode.
Cln: This message may appear on the display. If it does,
your cassette tape player needs to be cleaned. It will still
play tapes, but you should clean it as soon as possible to
prevent damage to your tapes and player. See "Care of
Your Cassette Tape Player'' in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the Cln indicator.
"---"
will appear in the display to
show the indicator was reset.
Write down any four-digit number and keep it in a safe
place. Then turn the ignition switch to the ACC or ON
position and the audio system off. Press the 1 and 4
buttons together. Hold them down until
"----
"
shows on
the display.
You are now ready to enter your security code. Don't
wait more than 15 seconds between steps.
Press 4 SEEK b or 4 TUNE and
"0000' will appear
on the display.
Press SEEK
4
and hold it until the first digit of y o w
c(:
!
aPpears. Release the button.
. . .
Theft-Deterrent Feature
The theft-deterrent feature for the A" stereo with
cassette tape player can be used or ignored. If ignored, the
system plays normally. If
it
is used, your system won't be
usable if it's ever stolen because it will go into LOC mode
anytime your vehicle loses battery power. The unlock code
must be entered or the radio will not turn on.
Setting Your Security Code
The following instructions will tell you how to enter a
security code into the system. If your vehicle loses
battery power for any reason, you must enter the
security code again before the system will turn on.
Press sEEK b and hold it until the second digit of your
code appears. Release the button.
Press TUNE 4 and hold it until the third digit of your
code appears. Release the button.
Press TUNE b and hold it until the fourth digit of your
code appears. Release the button.
Press AM-FM after you have checked that the code you
entered is the one you wrote down. "rEP' will appear on
the display, which means you need to repeat
steps 5
through 9.
Press AM-FM again and the display will now show
SEC.
3-10
Advertisement
