HP 2/20 Setting Up page 2

Follow these steps to get connected in minutes. Depending on the configuration ordered, some of these steps may
have been completed at the factory. For users unfamiliar with storage devices, please refer to the user guide for the
library. Note: Your library model might look different from the illustrations used on this poster.
Install Rack Components
Install the Library into a Rack
Install the clip nuts and mounting rails.
Ensure there is enough clearance between
the top and bottom rails for the library.
Note: The terms 20-slot, 40-slot and 60-slot
indicate maximum drive and slot capacity
for the library.
20-slot
40-slot
60-slot
Position the library so that
the side of the library faces
the front of an appropriately
rated mechanical lift. Align
the back of the library to the
rack and begin turning the
lift's hand crank until the
library is at the desired
height. Gently slide the
library into the rack.
Tip:
To reduce the weight of the library, you can
remove all the drives.
Note:
The 20-slot library can be safely installed by
two people without using a lift.