Appendix B. Performing Diagnostic and Maintenance
Functions
Table 9 describes each diagnostic and maintenance function that the 3580 Ultrium 2
Tape Drive can perform, gives its function code (which appears on the
single-character display), and directs you to the instructions for performing the
function. It is recommended that you use a scratch (blank) data cartridge for
diagnostic testing.
Table 9. Diagnostic and maintenance functions of the 3580 Ultrium 2 Tape Drive
Diagnostic or Maintenance Function
Causes the 3580 Ultrium 2 Tape Drive to run tests to determine
whether it can properly load and unload cartridges, and read and
write data.
Causes the 3580 Ultrium 2 Tape Drive to load updated firmware
from a field microcode replacement (FMR) tape.
Causes the 3580 Ultrium 2 Tape Drive to copy its field microcode
replacement (FMR) data to a scratch (blank) data cartridge.
Causes the 3580 Ultrium 2 Tape Drive to perform a dump of data
Causes the 3580 Ultrium 2 Tape Drive to copy data from a drive
dump (captured by using Function Code 4) to the beginning of a
scratch (blank) data cartridge.
Causes the 3580 Ultrium 2 Tape Drive to perform a check of the
SCSI circuitry from and to the SCSI connector.
Run RS-422 Wrap Test
Not available.
Causes the 3580 Ultrium 2 Tape Drive to erase the FMR data on a
scratch (blank) data cartridge and rewrite the cartridge memory on
the tape. This turns the cartridge into a valid scratch data cartridge.
Causes the 3580 Ultrium 2 Tape Drive to display the last 10 error
codes, one at a time (the codes are ordered; the most recent is
presented first and the oldest (tenth) is presented last).
© Copyright IBM Corp. 2003
Function Code
Not available
Location of
Instructions
Page 62
Page 64
Page 65
Page 67
Page 68
Page 69
Page 72
Page 73
59