Installing An Internal Dat Tape Drive; Prepare Mounting Bay - HP 157770-001 - DAT Drive 20/40 Tape User Manual

3 Installing an internal DAT tape drive

In this chapter:
• "Prepare mounting
• "Attach mounting
• "Install drive" on page 25
• "Attach USB
• "Attach USB and power cable to the tape
• "Secure the
Please refer to
DAT tape drive.
Where the illustrations in this chapter show only the HP StorageWorks DAT 320 tape drive, the
process is the same for all models of tape drive.

Prepare mounting bay

You need one industry-standard, 5¼-inch, half-height bay in which to install the HP StorageWorks
DAT tape drive. Different models of server require different mounting methods. Refer to your server
documentation for detailed information.
WARNING!
To avoid personal injury or damage to the server or tape drive, ensure that the server is disconnected
from the mains power supply while you install the drive.
CAUTION:
Static electricity can damage electronic components. Always wear an antistatic wriststrap if one is
available. If not, after you have disconnected power from the server and removed the cover, touch a
bare metal part of the chassis. Similarly, touch a bare metal part of the drive before installing it.
1. Refer to your server documentation for detailed instructions and assemble the necessary tools
and materials.
2. Perform a normal system shutdown and turn off the server and any connected peripherals.
3.
Remove the cover and access panel from the server, as detailed in your server's documentation.
As you work inside the server, you may have to disconnect other signal cables or power cables
from other devices to maneuver the new drive into place. If you have to do this, make a note of
their position and connections so you can put them back correctly later.
bay" on page 23
hardware" on page 24
cable" on page 25
drive" on page 30
"Installing an external DAT tape
drive" on page 28
drive" on page 31, if you are installing an external
DAT USB Tape Drives 23