Haier HMV1630DBBB Installation Manual page 70

Español
8. Asegure la unidad del ventilador al
microondas con el tornillo original.
9. Vuelva a colocar la placa del ventilador
en la misma posición que antes con
el tornillo. Asegúrese de que el tornillo
esté ajustado.
10. Attach the exhaust adaptor to the
rear of the oven by sliding it into the
guides at the top center of the back of
the oven. Push in securely until it is in
the lower locking tabs. Take care to
assure that the damper hinge is
installed so that it is at the top and that
the damper swings freely.
B6. MONTAJE DEL HORNO MICROONDAS
PARA QUE LA INSTALACIÓN SEA MÁS
FÁCIL Y POR MOTIVOS DE SEGURIDAD
PERSONAL, RECOMENDAMOS QUE
DOS PERSONAS INSTALEN EL HORNO
MICROONDAS
NOTA: Si su gabinete es de metal,
utilice la arandela aislante de nylon
para rodear el agujero para el cable de
energía para evitar que se corte el cable.
1. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
2. Rotate front of oven up against cabinet
bottom.
3. Insert a self-aligning screw through top
center cabinet hole. Temporarily secure
the oven by turning the screw at least two
full turns after the threads have engaged.
(It will be completely tightened later.) Be
sure to keep power cord tight. Be careful
not to pinch the cord, especially when
mounting flush to bottom of cabinet.
20
Adaptador
Guía
NOTA: Recomendamos el uso de
bloques de relleno si el frente del
gabinete cuelga por debajo del
estante inferior del gabinete
NOTE: When mounting the
microwave oven, thread power
cord through hole in bottom
of top cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven by
pulling cord.
2
Placa del ventilador
Parte trasera del
Microondas
Tornillo del motor
del ventilador
Parte trasera del
microondas
Guía
Lengüetas de cierre
1