Anti-Theft Protection; Basic Setting - Skoda CAR RADIO BLUES - FOR ROOMSTER Manual

The display can be cleaned with a soft cloth and finger marks can be wiped away with
pure alcohol.
Note
Do not use solvent such as turpentine or petrol as they will corrode the display
surface.

Anti-theft protection

Anti-theft coding
Your radio is equipped with a convenience coding. If the radio is being operated for the
first time, the safety code is not only stored in the radio but also in the vehicle.
After disconnecting and reconnecting the battery, first of all switch on the ignition and
then the radio.
If you wish to install the radio in another vehicle, the safety code must be entered. In
this case, please do not hesitate to contact a Škoda Service Partner or a Škoda importer.
As the unit only functions after entering the safety code, this practically excludes its use
after a theft - a contribution to increased anti-theft safety.
Note
The code is stored in the instrument cluster. This ensures that it is automatically
decoded (convenience coding). Manual input of the code is normally not necessary.
Enter code
– Switch on the radio if the ignition is on. SAFE is displayed and then 1000.
– Enter the safety code using the station keys
– Confirm the safety code by pressing the station key
If you have confirmed a wrongly entered code, you can repeat once again the entire
process.
- .
1 4
.
6
If the code number is entered incorrectly for the second time, the unit will be blocked
for approx. one hour. It is possible to enter again the safety code after one hour has
expired, when the unit and the ignition have been switched on.
The cycle - two attempts, blocked for an hour - will continue to apply.

Basic setting

Switching the unit on and off
– The system is switched on or off by pressing the control button
If the key is pulled out of the ignition lock while the unit is switched on, the unit will
switch off automatically. You can switch on the unit again by pressing the control
A
button . If the ignition is switched off, the unit (discharge protection of the vehicle
1
battery) switches off automatically after approx. one hour.
If you have switched off the radio by withdrawing the ignition key, the radio switches
on again once the ignition is on.
Tone settings
– Press the button repeatedly to select the desired parameter.

– Set the desired value by turning the rotary/push knob
You can select between the following parameters:

TRE - Treble setting;

BASS - bass setting;

BAL - setting of the volume ratio between the left and the right side;

FAD* - setting of the volume ratio between the front and the rear.
Setting the special functions
– Press the button , in order to activate the menu Setup.
MENU
General information 3
A
.
1
A
.
2