Verifying The Installation; Verifying The Installation Of The Drive (Unix); To Verify The Installation - HP LTO-4 Technical Reference Manual

8

Verifying the installation

Verifying the installation of the drive (UNIX)

As part of the installation process, you will have installed the appropriate device driver for your
UNIX system, and created device files to communicate with the tape drive.
This section describes how you can verify the installation has been performed correctly.
In outline, the procedure is as follows:
1. Check the tape drive responds to a rewind command.
2. Write test data to a tape.
Read the test data from the tape.
3.
4. Compare the data read from the tape with the original data on disk.

To verify the installation:

1. Test the SCSI connection to the tape drive by performing a rewind:
a. If there is a tape cartridge already in the drive, remove it.
b. Insert a new tape cartridge.
c. Rewind the tape using the command line:
% mt -f <device file> rewind
For example, on HP-UX 11i v1 or 11i v2
% mt -f /dev/rmt/c4t3d0BESTnb
For example, on HP-UX 11i v3 (using a persistent device file):
% mt -f /dev/rtape/tape0_BESTnb rewind
If the command completes successfully, there will be no feedback. If it fails, you will see an error
message on the console. There may be a reservation by another host, or a zone change, or the
hardware installation may be faulty. Check the troubleshooting section of the User's Guide for
help in identifying the problem.
2. Write a sample file to tape, using 'tar':
% cd /
% tar cvf <device file> <file>
The options to tar have the following meanings:
Create a new archive (backup file) on the device.
c
Operate in verbose mode.
v
Specify the device file explicitly.
f
HP LTO Ultrium 4 drives technical reference manual, volume 5: UNIX, Linux and OpenVMS configuration guide 37