Add Device Files - HP LTO-4 Technical Reference Manual

4. Select the
list. From the right hand panel on the web page, click the Modify Module link.
On the Modify Kernel Module: estape page, for Next Boot State, select the "static" radio button.
5.
Check the box entitled Backup to create a backup copy of the existing kernel (see
Figure 4 Adding
6. If you wish, type in a Reason for Change, such as "
1st 2007
Click the OK button at the Operation Successful page. Both
7.
now be shown with Next Boot State as "static".
8. For autoloaders, use a similar procedure to prepare the
From the right-hand panel on the Kernel Configuration page, click View Pending Changes and
9.
reboot and proceed to reboot the system as directed.
10.Following the reboot, re-run SMH and search again for the driver as in step 3 above. Current
State and Next Boot State should both be listed as "static".

Add device files

For HP-UX 11i v1, 11i v2
Use the utility to create device files.
sam
on a system with full graphics capability, or as a console text-based interface (see
13). If you use the text-based interface, use the Tab and arrow keys to navigate, and the Return key
to select.
1. Enter
sam
% sam
2. Select the following:
1. The
estape
HP LTO Ultrium 4 drives technical reference manual, volume 5: UNIX, Linux and OpenVMS configuration guide
1
module radio button. Its details will appear in a panel below the modules
estape
driver to the kernel
estape
" and then select the Modify tab.
at the command line:
and modules are linked, so it is sufficient to select the
stape
Initial estape installation May
eschgr
runs as a mouse driven GUI (see
sam
and drivers will
estape stape
(with ) module.
schgr
Figure 1
Figure 2
module alone for installation.
estape
Figure 4).
on page 12)
on page
15