Installation 6; Hardware Installation - Vivotek IP8161 User Manual

VIVOTEK
Hardware Reset
Status LED
Recessed Reset
Button
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the recessed reset button with a paper clip or thin object� Wait for the
Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks� It takes
about 30 seconds� Note that all settings will be restored to factory default� Upon successful
restore, the status LED will blink green and red during normal operation�
SD/SDHC Card Capacity
This network camera is compliant with SD/SDHC 16GB / 8GB and other preceding standard SD
cards�
Installation

Hardware Installation

Follow the steps below to mount the lens to the Network Camera:
1� Mount the lens by turning it clockwise onto the camera mount until it stops� If necessary, turn
the lens counterclockwise slowly until it gets the best attitude�
2� Connect the lens cable plug to the camera connector�
1
2
6 - User's Manual