Garmin nuvi 200 - Automotive GPS Receiver Instructions Manual page 3

For horizontal bars: Separate and
remove the top part of the mount, turn it
90 degrees, and replace. Continue with
step 2.
2. Place the wedge on the bicycle stem,
and then place the bicycle mount on
the wedge. Make sure the release lever
is on the left.
3. Thread the two cable ties through the
two slots on the bicycle mount. Position
the mount on your bicycle and attach
using the cable ties.
Release
lever
Cable ties
To attach the cradle to the bicycle
mount:
1. Fit the bottom of the nüvi in the cradle,
and snap the top of the nüvi into place.
2. Align the cradle with the bicycle mount.
3. Slide the cradle left onto the bicycle
mount until it snaps into place.
tip: Change the Usage Mode on your
nüvi. Touch
usage Mode > Bicycle.
To release the cradle:
1. Remove the nüvi from the cradle.
2. Press down on the release lever, and
slide the cradle to the right.
> Settings > System >
EN-3