To Add, Program Or Change A Keyless Entry Pin (Not Provided) - Chamberlain Security+ 3950 Owner's Manual

NOTE: The optional Keyless Entry must be programmed to operate your door operator.
USING THE "LEARN" BUTTON
1. Press and release the purple "learn"
button on motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad. Then press
and hold the ENTER button.
3. Release the button when the learn
indicator light blinks and shuts off upon
learning the remote control. If the
optional remote light is installed, the light
will blink.

To Add, Program or Change a Keyless Entry PIN (Not Provided)

Optional
To change an existing, known PIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and hold
the # button.
The operator light will blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen, then press Enter.
The motor unit lights will blink once when the PIN has
been learned.
Test by pressing the new PIN, then press Enter. The door
should move.
To set a temporary PIN
You may authorize access by visitors or service people with
a temporary 4-digit PIN. After a programmed number of hours or
number of accesses, this temporary PIN expires and will no
longer open the door. It can be used to close the door even after it
has expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the last
temporary PIN), then press and hold the button.
The operator light will blink three times. Release the button.
2. Press the temporary 4-digit PIN you have chosen, then
press Enter.
3. To set the number of hours this temporary PIN will work, press
the number of hours (up to 255), then press ✽.
NOTE: If the optional remote light is installed, the remote light will
blink 4 times.
20