Prince_Page_5.pdf
Stage 2 - Installing the PRINCE in the car
Installing with a lap and diagonal seat-belt
- Do not use any load bearing contact points other than those described in the instructions and
IMPORTANT
marked in the child restraint.
Have you adjusted the harness to the correct position for your child?
If not, see Stage 1 on page 3.
1
Place the PRINCE forward facing on the car seat and
C
pull the harness tight.
M
Y
3
CM
MY
CY
Fasten the seat-belt.
5
Press the red lock open.
12/09/2008
15:14:20
4
Before going any further make sure that the lap section of the
seat-belt passes below both lap belt guides.
2
Pass the seat-belt through both side slots.
6
Pull the diagonal section through the red lock. Make
sure that the seat belt is not twisted.
Lap belt
guide
.
page 5