Using Flash - NAIM CD5I Owner's Manual

Flash Handset
17.1 Introduction
Flash is factory pre-programmed to operate any Naim
preamplifier or cd player, the NAT 05 tuner and AV2
audio-visual processor. Additional Naim sources may be
catered for in the future. Contact your dealer or local
representative for information.
Flash is supplied without batteries fitted. To fit the batteries,
remove the battery cover with the supplied hexagon driver and
slide the batteries into the handset body taking care with their
orientation. Replace the battery cover. Do not over-tighten the
fixing screw. With batteries fitted the handset is ready for use.
Flash is designed to switch off if unused after 10 seconds. It
switches on immediately if it is moved or a key is pressed.
equipment modes have multiple display "pages" (only one page
is necessary for Tuners). The first display page of each provides
control of the most commonly used functions, with subsequent
pages generally providing access to those less often used.
Selection of second and third pages within each mode is made
by pressing the appropriate
page is shown in the top right corner of the display. Details of
the master key functions within each page is described in the
following paragraphs:

17.2 Using Flash

Flash can be set to control each
equipment type through the
preset
four keys beneath the
display. The selected equipment
mode is indicated in the display
above each preset key. When
a preset key is pressed the
display and the eight master
keys and the numeric keys will
re-configure appropriately. The
display for each equipment type
shows a representation of the
eight master keys and their
functions.
AV preset
The key will also
wake an av processor from
standby. Press and hold the
AV preset key to return the
processor to standby mode.
The volume up and down and
mute keys are always available
to control the appropriate
(audio-visual or preamplifier)
volume and mute functions
regardless of the selected
source equipment mode.
The Preamplifier, CD, and AV
preset
key. The currently selected
PRE (preamplifier mode)
Page 1 of 2
source + Selects the next input source.
source - Selects the previous input source.
<bal Adjusts balance to the left.
bal> Adjusts balance to the right.
prog Enters programming mode on preamplifiers.
disp Selects display options on appropriately
equipped preamplifiers.
mono Sums the left and right channels.
Note: On Naim preamplifiers with no mono
facility, operates the tape monitor function.
menu
Accesses a Flash setup page where source
labels can be chosen, and display preferences
can be set. Also provides access to RC5 setup.
numeric Directly selects preamplifier input channels.
Page 2 of 2
The master key functions on
Page One. However, selection of Page Two provides control of
the record functions on appropriately equipped preamplifiers.
CD (cd mode)
Page 1 of 2
play Begins cd play
stop Stops cd play
prev Selects the previous track or index point
next
Selects the next track or index point
pause Pauses cd play
disp Cycles the cd player display through track,
time and off options.
rev Fast reverses cd
fwd Fast forwards cd
numeric Directly select CD tracks.
Page 2 of 2
The master key functions play, stop, prev, next, rev
CD Page Two are duplicates of
Page Two provides programming and repeat functions.
prog Enters CD track programming mode.
rep Repeats the CD or programmed tracks.
numeric Selects CD tracks or index points for
programming.
TUN (tuner mode)
Page 1 of 1
up Depending on the operational mode selected,
adjusts the tuning frequency upwards
(frequency mode), searches for stations up
the FM band (scan mode)
station preset (preset
down Operates in the same manner as the
prog Selects preset program mode that enables
FM stations to be assigned to preset memory.
disp Switches the tuner display on or off.
mono Combines the left and right channels
and may improve reception on weak signals.
mode Selects frequency, scan and preset modes.
numeric Directly select station presets.
PRE Page Two are duplicates of
and fwd
Page One. However, selection of
or selects the next
mode).
up key.
on
17