Installing The Canopy And Canopy; Trim Ring - Hunter 20168 Owner's Manual And Installation Manual

Type 2 models

Hide thumbs Also See for 20168:

Table of Contents

5 • Installing the Canopy and Canopy Trim Ring

WARNING: Failure to complete the following steps could cause the fan

to fall.

Note: It is recommended you use a magnetic tip screwdriver for the

following steps.

5-1. Rotate the hanger ball so the tab in the canopy is secure in the

hanger ball groove. Note: Your fan may have multiple tabs and

grooves that must be aligned.

5-2. Swing the fan up to align the canopy screw holes with the

mounting holes on the ceiling plate.

WARNING: The slots in the canopy must remain engaged while

swinging the canopy for alignment.

5-3. Holding the canopy up with the screw holes aligned, partially

install two canopy screws into the holes opposite the ceiling plate

tabs.

5-4. Partially install a canopy screw into the hole between the two

ceiling plate tabs.When all the holes are properly aligned, securely

tighten all three canopy screws.

5-5. Verify that the tabs in the canopy are still in the grooves of the

hanger ball.

5-6. Align the tabs on the trim ring opposite the grooves in the hanger

ball. Using both hands, push the canopy trim ring up to the top of

the canopy. The canopy trim ring will snap and lock into place.

Note: Should you need to remove the trim ring, press firmly on

opposite sides of the trim ring directly above the groove in the

hanger ball. The tabs will flex out releasing the canopy trim ring.

42699-01 • 06/30/10 • Hunter Fan Company

Step 5-1

Tab

Groove

Step 5-2

Step 5-3

Canopy

Trim

Ring

Canopy Screw

Table of Contents