Advertisement
Installation
Installing the Control Unit
Installation using the flush mounting bracket (Fig. 7)
Fit the flush mounting bracket into
the opening in the dashboard, raise
the claws of the bracket with a flat-
bladed screwdriver, and secure the
bracket in place.
124 – 126 mm
Dashboard
Flush mounting bracket
Open the installation hole.
Screws
Holder
Removing the control unit (Fig. 8)
Insert the release plate that comes with the
unit as shown in the illustration.
Pull it towards you.
Fig. 7
Fasten the control unit with velcro tape (Fig. 9)
Velcro tape
(Rough surface)
Fig. 8
Note:
• Thoroughly wipe off the surface before affixing the velcro tape.
• Obviously, it is very dangerous if the cord gets tangled in the steering wheel, so install the cord so
that it cannot get in the way.
Dashboard
Velcro tape
(Soft surface)
Fig. 9
Advertisement
