Advertisement
Installation
Note:
• Before finally installing the unit, connect the
• Do not mount this unit near the heater outlet,
wiring temporarily, making sure it is all connected
where it would be affected by heat, or near the
up properly, and the unit and the system work
doors, where rainwater might splash onto it.
properly.
• Before drilling any mounting holes always check
• Use only the parts included with the unit to ensure
behind where you want to drill the holes. Do not
proper installation. The use of unauthorized parts
drill into the gas line, brake line, electrical wiring
can cause malfunctions.
or other important parts.
• Consult with your nearest dealer if installation
• If this unit is installed in the passenger compart-
requires the drilling of holes or other modifications
ment, anchor it securely so it does not break free
of the vehicle.
while the car is moving, and cause injury or an
• Install the unit where it does not get in the driver's
accident.
way and cannot injure the passenger if there is a
• If this unit is installed under a front seat, make sure
sudden stop, like an emergency stop.
it does not obstruct seat movement. Route all leads
• When mounting this unit, make sure none of the
and cords carefully around the sliding mechanism
leads are trapped between this unit and the sur-
so they do not get caught or pinched in the mecha-
rounding metalwork or fittings.
nism and cause a short circuit.
Installing the Tuner Unit
Mounting with Brackets (Fig. 6)
Tapping screw (4 12 mm)
Bracket
Car mat or chassis
Drill 2 to 2.5 mm diameter holes.
Screw (4 6 mm)
Fig. 6
Advertisement
