Connecting Wires To Terminals - Kenwood KDC-BT948HD Instruction Manual

Connecting Wires to Terminals

To USB device
USB connector
(0.8 m (2.7 ft))
Microphone input
Microphone
(Accessory5)
Wiring harness
(Accessory1)
Blue/White (Power control wire)
Blue (Antenna control wire)
Brown (Mute control wire)
Orange / White (Dimmer control wire)
Light Blue/Yellow (Steering remote control)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) · (To car chassis)
68
|
KDC-X995/ KDC-BT948HD
Do not remove the cap
⁄
when you do not use the
USB cable. The connector
will cause the unit to
malfunction if it gets in
touch with any metallic
part of the vehicle.
Fuse (10A)
White
To front left speaker
White/Black
Gray
Gray/Black To front right speaker
Green
To rear left speaker
Green/Black
Purple
Purple/Black To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
terminal.
P.CONT
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
ANT.
CONT amplifier of the film-type or short pole type antenna.
To connect the Kenwood navigation system, consult your navigation
manual.
MUTE
To car light control switch
ILLUMI
To use the steering wheel remote control feature, you need to an
REMOTE
exclusive remote adapter (not supplied) matches your car is required.
CONT
STEERING
WHEEL
REMOTE
INPUT
Car fuse
box
ACC
R
FM/AM antenna input
R L
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
(3.5 mm (1/8") ø)
To Kenwood disc changer/ External optional accessory
To connect these leads, refer to the relevant
⁄
instruction manuals.
Ignition key
switch
Car fuse box
(Main fuse)
+
–
Battery
Rear output
L
Front output
Sub Woofer output
Antenna Cord