Operations; How To Read; Sirius Id [Esn] Display; Select Sirius Satellite Rddio Mode - Kenwood KCA-SR50 - Complete Sirius Satellite Radio System Instruction Manual

Operations
How to read
The operation method differs depending on the
model of the control unit.
For the model with a Control knob, perform the
operation steps marked with
E1.
For other models,
perform the operation steps marked with
II.
SIRIUS ID [ESN] display
You must have the SIRIUS ID number [ESN] for
licensing with SIRIUS Corp. Check the SIRIUS ID
[ESN] ofthis unit as follows.
1
Select the SIRIUS Satellite Radio Mode
Press the [SRC] button.
Select the ISIRIUS I I"SAT" display.
2
Check the SIRIUS 10 [ESN] of this unit
See the <Menu System> page of the instruction
manual of your control unit, and select the ESN
menu item.
The SIRIUS
10
[ESN] will be displayed.
E2
• Serial & SIRIUS 10 [ESNj
It is especially important to retain the unit serial number
and the electronic SIRIUS Identification number for
service activation and potential future service changes.
Select SIRIUS Satellite Radio Mode
Listening to the SIRIUS satellite radio.
Press the [SRC] button.
Select the
II
SIRIUSII"SAT" display.
Q...
~
• You need to subscribe to SIRIUS to receive the service
by SIRIUS Satellite Radio. Consult SIRIUS if "CALL 888-539
SIRIUS TO SUBSCRIBE"/"CALL 888 539-SIRI" appears.
It may take a little time to start receiving after you
selected the SIRIUS source.
If the signal receiving fails, "Acquiring Signal"/
"ACQUIRING SIGNAL" appears.
Selecting the Preset Band
E1
Push the Control knob toward up.
Each time you push the knob toward up, it
switches between the SR1, SR2, SR3 and SR4.
II
Press the [FM] button.
Each time the button is pressed, the preset band
switches between the SR1, SR2, SR3 and SR4.
Tuning
Selecting the channel.
E1
Push the Control knob towards right or left.
II
Press the [~] or [~] button.
Channel Preset Memory
Putting the channel in the memory.
1
Select the preset band
E1
Push the Control knob toward up.
II
Press the [FM] button.
2
Select the channel to put in the memory
E1
Push the Control knob towards right or left.
II
Press the
[~]
or
[~]
button.
3
Put the channel in the memory
Press the desired
[1] -
[6] button for at least 2
seconds.
The preset number display blinks 1 time.
On each band, 1 station can be put in the memory
on each [1] - [6] button.
E2
• Only the channel number is stored. Category information
is not stored.
• This function can be used only when the "Channel"/
"CHANNEL" has been selected in <Switching Seek
Mode> (page 6).
Preset Tuning
Calling up the channels in the memory.
1
Select the preset band
E1
Push the Control knob toward up.
II
Press the [FM] button.
2
Call up the channel
Press the desired
[1] -
[6] button.
English
I
5