Setup Instructions - Harman Kardon HKTS 200BQ Owner's Manual

HKTS 60BQ
Front Left
Speaker Cable
(White Bands)
FRONT
+ –
+ – + –
Receiver
Surround Left
Speaker Cable
(Blue Bands)
Surround
Left
Connecting the Subwoofer to a Receiver or
Preamp/Processor With a Dedicated Subwoofer Output
Use this installation method for receivers and preamp/processors that have a
dedicated subwoofer output with low-pass filtering (also called bass management).
If the dedicated subwoofer output does not have low-pass filtering, follow the
instructions in Connecting the Subwoofer to a Receiver or Preamp/Processor With
Line Outputs, on page 9.
Use the LFE (purple) connector of the supplied combination LFE and trigger
cable to connect the HKTS200SUB's Line-Level LFE In Jack 5 to the dedicated
subwoofer output (or LFE output) of your receiver or preamp/processor.
Front Left
Speaker Cable
(Green Bands)
– +
SURROUND CENTER
+ –
– +
RIGHT
LEFT
SUB
LFE OUT
– – + +
– +
Center
Center
– +
LFE/Trigger Cable
(Purple Ends)
Surround Right
Speaker Cable
(Gray Bands)
Connect each satellite speaker and the center speaker to the corresponding
speaker terminals on your receiver or amplifier.
Configure your receiver or preamp/processor's setup menu for Subwoofer ON,
and set the front left, front right, center and surround speakers to Small. After
you have made and verified all connections, plug the HKTS200SUB's AC Power
Cord 8 into an active AC outlet.
8
Front Right
Front Right
Speaker Cable
(Red Bands)
– +
Subwoofer
– +
Surround
Right

Setup Instructions

PL0004-01001