Chapter 4. Installation And Configuration; Installing Your Library; Using The Library Configuration Form; Choosing A Location - Dell PowerVault TL2000 User Manual

Chapter 4. Installation and Configuration

Installing Your Library

Using the Library Configuration Form

Choosing a Location

Table 4-1. Location criteria
Criteria
Room temperature
Power source
Air quality
Humidity
Note: Review the information in "Installation Planning" before installing your
library.
To install a desktop or rack mounted 2U library or 4U library, perform the
procedures in this chapter in the order they are presented.
Complete these procedures to install your library hardware.
1. "Using the Library Configuration Form."
2. "Choosing a Location."
3. "Unpacking the Library" on page 4-2.
4. "Verifying the Shipment" on page 4-2.
5. "Installing the Library Foot Pads (for Desktop Installation ONLY)" on page 4-3.
6. "Removing and Storing the Shipping Lock" on page 4-4.
7. "Rackmounting the Library (for Rack Installation ONLY)" on page 4-6.
8. "Connecting the Host Interface Cable" on page 4-12.
9. "Connecting a Power Cord" on page 4-13.
Before beginning the installation and configuration of your library, make a copy of
the Appendix F, "Library Configuration Form," on page F-1. Enter library
information (such as serial numbers, types of drives, etc.) and configuration
settings on the Library Configuration Form and store in a safe location for future
reference. Be sure to update this form any time changes are made to your library
hardware or configuration.
Choose a location that meets the following criteria:
Definition
10° - 35° C (50° - 95° F )
v AC power voltage: 100-127 VAC; 200-240 VAC (4 - 2 A)
Note: The 4U library requires two separate power sources to implement redundant
power.
v Line frequency: 50-60 Hz
Place the library near an AC outlet. The AC power cord is the product's main AC
disconnect device and must be easily accessible at all times.
The library should be placed in an area with minimal sources of particulate contamination.
Avoid areas near frequently used doors and walkways, stacks of supplies that collect dust,
printers, and smoke-filled rooms. Excessive dust and debris can damage tapes and tape
drives.
15-80 % RH non-condensing
4-1