Ami System Bios - HP 8000 - Elite Convertible Minitower PC Software Configuration Manual

9. To apply and save changes, select File > Save Changes and Exit.
 If you have made changes that you do not want applied, select Ignore
Changes and Exit.
 To reset to factory settings or previously saved default settings (some
models), select Apply Defaults and Exit. This option will restore the original
factory system defaults.
CAUTION:
Do NOT turn the computer power OFF while the BIOS is
saving the Computer Setup (F10) changes because the
CMOS could become corrupted. It is safe to turn off the
computer only after exiting the F10 Setup screen.

AMI System BIOS

HP systems (AiO) that uses an AMI BIOS can access the Virtualization option as
follows.
Do the following to enable processor virtualization:
1. Turn on or restart the computer.
2. As soon as the computer is turned on, press F10 when the monitor light turns
green to enter Computer Setup. Press Enter to bypass the title screen, if
necessary.
NOTE:
If you do not press F10 at the appropriate time, you must
restart the computer and again press F10 when the
monitor light turns green to access the utility.
3. Select your language from the list and press Enter.
4. A choice of five headings appears in the Computer Setup Utilities menu: Main,
Advanced, Power, Boot, and Exit.
5. Use the arrow (left and right) keys to select the appropriate heading. Use the
arrow (up and down) keys to select the option you want, then press Enter. To
return to the Computer Setup Utilities menu, press Esc.
6. Select Power.
7. Set Virtualization Technology to Enable.
7