4.12
Speaker Assembly
1. Prepare the computer for disassembly (Section 4.2).
CAUTION: When the computer is plugged into an AC power source, there is always voltage
applied to the system board. You must disconnect the power cord from the power source before
opening the computer to prevent system board or component damage.
2. Remove the computer cover (Section 4.6).
3. Rotate the drive cage to the upright position.
4. Disconnect the speaker wire from the P6 connector on the system board
5. Remove the four nuts that connect the speaker assembly to the chassis
✎
Use a 5/16-inch socket to remove the nuts from the speaker assembly.
6. Remove the speaker assembly
To replace the speaker assembly, reverse the removal procedures.
4-18
Removal & Replacement Procedures
3
.
1
.
2
.