Fb-Dimm Architecture - HP 117755-003 - ProSignia - 740 Overview

Memory technology evolution: an overview of system memory technologies, 8th edition
Hide thumbs Also See for 117755-003 - ProSignia - 740:
Table of Contents

Advertisement

Consequently, JEDEC developed the Fully-Buffered DIMM (FB-DIMM) specification, a serial interface
that eliminates the parallel stub-bus topology and allows higher memory bandwidth while maintaining
or increasing memory capacity.

FB-DIMM architecture

The FB-DIMM architecture has serial links between the memory controller and the FB-DIMMs, which
are connected in a daisy chain configuration (Figure 15). Relative to the memory controller, there are
10 outbound links and 14 inbound links, also known as southbound and northbound links,
respectively. These serial links connect the memory controller to an advanced memory buffer (AMB)
chip that resides on each FB-DIMM, creating a point-to-point architecture. The outbound links transmit
commands and write data to the FB-DIMMs while the inbound links transmit read data back to the
memory controller.
The clock signal is distributed over a different set of pins. In addition to communicating over the
Outbound lanes, the memory controller communicates configuration information with each AMB over
the SMBus. The AMB is an intelligent chip that manages serial communication with the memory
controller and parallel communication with local DRAM devices. Each AMB receives signals (address,
write data, and command information) through the outbound links and re-transmits the signal to the
next FB-DIMM on the channel. Each AMB decodes the command data and ignores the commands that
are targeted for a different DIMM. The targeted AMB performs a read or write operation to local
DRAM devices through a parallel interface. In the case of a read operation, the AMB serializes data
from the DRAM devices and transmits it to the memory controller through the inbound links.
Figure 15. Serial communication between daisy-chained FB-DIMMs on a single channel.
When using DDR2-667 DRAM on the FB-DIMM, the peak theoretical throughput of the inbound links
is 5.4 GB/s. The peak theoretical throughput of the outbound links is half the amount of data as the
inbound links, approximately 2.6 GB/s.
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

124708-001 - proliant cluster - 1850153636-001 - neoserver - 150292970-001 - prosignia - 200386819-001 - prosignia - 720Bl10e - hp proliant - 512 mb ramCl380 - proliant - 256 mb ram ... Show all

Table of Contents